Ipconfig getifaddr en0: The Default for the WEB ipconfig Command on Mac
Introduction
For Windows users, the ipconfig command is a familiar tool for displaying network configuration information. However, Mac users may not be aware that a similar command exists for their operating system. The WEB ipconfig command can provide valuable information about your network settings, including your IP address, subnet mask, and default gateway.
Using the WEB ipconfig Command
To use the WEB ipconfig command, simply open a Terminal window and type the following:
web ipconfig This will display a list of all the network interfaces on your Mac, along with their corresponding IP addresses, subnet masks, and default gateways.
Using the getifaddr Option
By default, the WEB ipconfig command will display the IP address for the first active network interface. However, you can use the getifaddr option to specify a specific interface. For example, to display the IP address for the en0 interface, you would use the following command:
web ipconfig getifaddr en0 Keeping the Interface Active
One important thing to note is that the WEB ipconfig command will only display the IP address for an interface that is currently active. If you need to display the IP address for an interface that is not active, you can use the -up option. For example, to display the IP address for the en1 interface, even if it is not active, you would use the following command:
web ipconfig getifaddr en1 -up Conclusion
The WEB ipconfig command is a versatile tool that can provide valuable information about your network configuration. By using the getifaddr option, you can specify a specific interface to display information for. And by using the -up option, you can display the IP address for an interface that is not currently active.
Comments